Login

Fiat 500-abarth Recalls

There are currently 6 safety recalls out on the Fiat 500-abarth. To find out whether your car is affected, you'll need to find your car's VIN number.

How to find your VIN

The VIN can often be found on the lower-left corner of the dashboard, in front of the steering wheel.

You can read the number by looking through the windshield. The VIN may also appear in a number of other locations:

  • Front of the engine block. This should be easy to spot by opening the bonnet, and looking at the front of the engine.
  • Front of the car frame, near the container that holds windshield washer fluid.
  • Rear wheel well. Try looking up, directly above the tyre.
  • Inside the driver-side doorjamb. Open the door, and look underneath where the side-view mirror would be located if the door was shut.
  • Driver-side doorpost. Open the door, and look near the spot where the door latches, not too far from the seatbelt return.
  • Underneath the spare tyre.
VIN Location Diagram

If you still can't locate the VIN, try consulting your vehicle manual. Or, call a dealership or the manufacturer and request guidance.

Step 2 - See if your car is affected
  • Announcement date:
    09/09/2022
    Recalls number:
    R/2022/187
    VIN start:
    *********NJG14588
    VIN end:
    *********NJG18062
    Car Build Date:
    22/03/2022 - 30/03/2022
    Concern:
    Ineffective/incorrect Tightening Of A Lock Nut On The Steering Gear Rod
    Defect:
    Vehicles may have been produced with ineffective/incorrect tightening of a lock nut on the steering gear rod.
    Remedy:
    Check for the correct tightening of the lock nut and check/adjust wheel alignment if tightening was required.

  • Announcement date:
    12/02/2021
    Recalls number:
    R/2021/019
    VIN start:
    *********0JD77396
    VIN end:
    *********0JD80992
    Car Build Date:
    20/03/2020 - 27/07/2020
    Concern:
    The "sport" Mode System May Not Be Set Correctly And Therefore May Not Comply With Type Approval Requirements
    Defect:
    The
    Remedy:
    The proxi file must be updated to solve the non conformity.

  • Announcement date:
    23/09/2016
    Recalls number:
    R/2016/194
    VIN start:
    ZFA3120000J516840
    VIN end:
    ZFA3120000J527059
    Car Build Date:
    07/12/2015 - 27/06/2016
    Concern:
    Seat May Not Perform As Expected During A Collision
    Defect:
    The seat may not remain in position when subjected to greater than normal driving forces such as those involved in an impact. This may possibly cause injury to the driver/passenger seated in the right hand front seat. The right hand front seat guides may not conform to design specification and installation specifications.
    Remedy:
    Recall the vehicles that are likely to be affected and check the installation of the original seat guide. If it does not conform replace the seat cushion structure (guide).

  • Announcement date:
    10/04/2015
    Recalls number:
    R/2015/077
    VIN start:
    ZFA3120000J281982
    VIN end:
    ZFA3120000J286237
    Car Build Date:
    01/09/2014 - 20/11/2014
    Concern:
    Front Seatbelts May Not Function As Intended
    Defect:
    It has been identified that the front seatbelt anchorage links may not have been manufactured to the correct specification. If the link is subjected to an abnormal force then it may not perform as required.
    Remedy:
    Recall all the affected vehicles to check the link and if required replace it.

  • Announcement date:
    22/09/2014
    Recalls number:
    R/2014/089
    VIN start:
    ZFA31200000757836
    VIN end:
    ZFA31200000997473
    Car Build Date:
    12/09/2011 - 09/05/2014
    Concern:
    Interior And Exterior Vehicle Lighting May Fail
    Defect:
    It is possible under extreme conditions that the wiring harness under the dashboard could come into contact with the steering column. This over a period of time may result in the chaffing of wires in the harness. If this should occur then it is possible both the exterior and instrument lights could fail.
    Remedy:
    Recall all affected vehicles to provide additional security of the wiring loom.

  • Announcement date:
    22/09/2014
    Recalls number:
    R/2014/089
    VIN start:
    ZFA3120000J000001
    VIN end:
    ZFA3120000J201532
    Car Build Date:
    12/09/2011 - 09/05/2014
    Concern:
    Interior And Exterior Vehicle Lighting May Fail
    Defect:
    It is possible under extreme conditions that the wiring harness under the dashboard could come into contact with the steering column. This over a period of time may result in the chaffing of wires in the harness. If this should occur then it is possible both the exterior and instrument lights could fail.
    Remedy:
    Recall all affected vehicles to provide additional security of the wiring loom.
Step 3 - Contact your nearest dealer

Enter your postcode to see your nearest franchised dealer: