Login
My Garage
  1. Home
  2. Recalls
  3. Mitsubishi L200

Mitsubishi L200 Recalls

There are currently 20 safety recalls out on the Mitsubishi L200. To find out whether your car is affected, you'll need to find your car's VIN number.

How to find your VIN

The VIN can often be found on the lower-left corner of the dashboard, in front of the steering wheel.

You can read the number by looking through the windshield. The VIN may also appear in a number of other locations:

  • Front of the engine block. This should be easy to spot by opening the bonnet, and looking at the front of the engine.
  • Front of the car frame, near the container that holds windshield washer fluid.
  • Rear wheel well. Try looking up, directly above the tyre.
  • Inside the driver-side doorjamb. Open the door, and look underneath where the side-view mirror would be located if the door was shut.
  • Driver-side doorpost. Open the door, and look near the spot where the door latches, not too far from the seatbelt return.
  • Underneath the spare tyre.
VIN Location Diagram

If you still can't locate the VIN, try consulting your vehicle manual. Or, call a dealership or the manufacturer and request guidance.

Step 2 - See if your car is affected
  • Announcement date:
    10/07/2019
    Recalls number:
    R/2019/193
    VIN start:
    MMCJYKL10GH000227
    VIN end:
    MMCJYKL10GH236277
    Car Build Date:
    23/04/2015 - 03/08/2016
    Concern:
    Side Step Shade Rivets May Corrode And Fracture
    Defect:
    Corrosion of fixing rivets can lead to the side step shade becoming insecure
    Remedy:
    Change the 12 aluminium rivets to M8 bolts and nuts
  • Announcement date:
    10/07/2019
    Recalls number:
    R/2019/193
    VIN start:
    MMCJJKL20GH000225
    VIN end:
    MMCJJKL20GH236400
    Car Build Date:
    23/04/2015 - 03/08/2016
    Concern:
    Side Step Shade Rivets May Corrode And Fracture
    Defect:
    Corrosion of fixing rivets can lead to the side step shade becoming insecure
    Remedy:
    Change the 12 aluminium rivets to M8 bolts and nuts
  • Announcement date:
    10/07/2019
    Recalls number:
    R/2019/193
    VIN start:
    MMCJJKL10GH000221
    VIN end:
    MMCJJKL10GH236405
    Car Build Date:
    23/04/2015 - 03/08/2016
    Concern:
    Side Step Shade Rivets May Corrode And Fracture
    Defect:
    Corrosion of fixing rivets can lead to the side step shade becoming insecure
    Remedy:
    Change the 12 aluminium rivets to M8 bolts and nuts
  • Announcement date:
    30/11/2016
    Recalls number:
    R/2016/251
    VIN start:
    MMBENKB407D000321
    VIN end:
    MMCENKB40FD841057
    Car Build Date:
    07/11/2005 - 30/03/2015
    Concern:
    Airbag May Release Shrapnel If Deployed
    Defect:
    Certain driver side airbags the inflator might release shrapnel from the inflator container during deployment which could injure the driver.
    Remedy:
    On affected vehicles replace air bag inflator.
  • Announcement date:
    30/11/2016
    Recalls number:
    R/2016/251
    VIN start:
    MMBJRKB407D000337
    VIN end:
    MMCJRKB409D010100
    Car Build Date:
    05/11/2005 - 30/03/2015
    Concern:
    Airbag May Release Shrapnel If Deployed
    Defect:
    Certain driver side airbags the inflator might release shrapnel from the inflator container during deployment which could injure the driver.
    Remedy:
    On affected vehicles replace air bag inflator.
  • Announcement date:
    30/11/2016
    Recalls number:
    R/2016/251
    VIN start:
    MMBJNKB407D000323
    VIN end:
    MMCJNKB40FD839801
    Car Build Date:
    07/11/2005 - 30/03/2015
    Concern:
    Airbag May Release Shrapnel If Deployed
    Defect:
    Certain driver side airbags the inflator might release shrapnel from the inflator container during deployment which could injure the driver.
    Remedy:
    On affected vehicles replace air bag inflator.
  • Announcement date:
    30/11/2016
    Recalls number:
    R/2016/251
    VIN start:
    MMBCNKB407D010925
    VIN end:
    MMCCNKB40FD841063
    Car Build Date:
    07/11/2005 - 30/03/2015
    Concern:
    Airbag May Release Shrapnel If Deployed
    Defect:
    Certain driver side airbags the inflator might release shrapnel from the inflator container during deployment which could injure the driver.
    Remedy:
    On affected vehicles replace air bag inflator.
  • Announcement date:
    28/07/2016
    Recalls number:
    R/2016/155
    VIN start:
    MMTJNKB407D000420
    VIN end:
    MMTENKA407D005751
    Car Build Date:
    12/07/2005 - 14/10/2005
    Concern:
    Indicators And/or Other Vehicle Lights May Switch Off Or Blink Without Warning
    Defect:
    Due to poor connectivity the indicators and/or vehicle lights may turn off or blink
    Remedy:
    On affected vehicles apply lubricant to switch connections
  • Announcement date:
    03/12/2013
    Recalls number:
    R/2013/134
    VIN start:
    MMCJNKB40BD030964
    VIN end:
    MMCJNKB40CD017239
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Vehicle May Become Unstable
    Defect:
    Either side front lower suspension arm can be damaged or broken due to improper welding by the supplier. This could cause the vehicle to pull to either side or can be unstable during driving.
    Remedy:
    Recall the vehicles that are likely to be affected to check and where necessary replace any defective lower suspension arms.
  • Announcement date:
    03/12/2013
    Recalls number:
    R/2013/138
    VIN start:
    MMCJYKB40CD000674
    VIN end:
    MMCJYKB40ED002092
    Car Build Date:
    05/11/2011 - 23/09/2013
    Concern:
    Possible Risk Of Fire
    Defect:
    It is possible that a poorly soldered joint could cause a high resistance on the Door Entry Guard circuit board. This can cause a risk of fire.
    Remedy:
    Recall all affected vehicles to check unit and replace if required.
  • Announcement date:
    03/12/2013
    Recalls number:
    R/2013/138
    VIN start:
    MMCJNKB40CD000631
    VIN end:
    MMCJNKB40ED007971
    Car Build Date:
    05/12/2011 - 23/09/2013
    Concern:
    Possible Risk Of Fire
    Defect:
    It is possible that a poorly soldered joint could cause a high resistance on the Door Entry Guard circuit board. This can cause a risk of fire.
    Remedy:
    Recall all affected vehicles to check unit and replace if required.
  • Announcement date:
    03/12/2013
    Recalls number:
    R/2013/133
    VIN start:
    MMCJYKB40CD005385
    VIN end:
    MMCJNKB40CD006497
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Fuel May Leak
    Defect:
    Poor welding may have occurred on the front prop shaft due to a manufacturing equipment failure on the supplier's production line. In the worst case the weld may break and the prop shaft may interfere with and damage the fuel line sufficiently for fuel to leak.
    Remedy:
    Recall the vehicles that are likely to be affected to check and where necessary replace the propeller shaft.
  • Announcement date:
    03/12/2013
    Recalls number:
    R/2013/132
    VIN start:
    MMTJRKB807D001150
    VIN end:
    MMBJRKB407D134510
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    In Extreme Cases Fire May Occur
    Defect:
    Due to an incorrect shape of the power seat reclining lever the switch may get stuck. This causes current to flow through the reclining motor which heats up. In the worst case the cushion from the power seat and surrounding parts may be damaged due to heat generated from the reclining motor.
    Remedy:
    Recall the vehicles that are likely to be affected to replace the powered seat recliner levers and where necessary the adjuster assemblies.
  • Announcement date:
    28/06/2013
    Recalls number:
    R/2013/054
    VIN start:
    MMCJNKB40CD000021
    VIN end:
    MMCJYKB40DD003034
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Engine May Stall
    Defect:
    As a result of incorrect mapping of the ECU and/or inappropriate design of the air flow sensor connector low engine performance poor idling or in the worst case engine stalling might be experienced.
    Remedy:
    Recall the vehicles that are likely to be affected to re programme the ECU and where necessary replace the air flow sensor.
  • Announcement date:
    18/08/2010
    Recalls number:
    R/2010/082
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Top Suspension Ball Joint May Become Detached
    Defect:
    It has been established that is it possible due to misalignment of components that the ball joint mounting bolts may not have been torqued to the correct specification. If the vehicle is used in extreme circumstances this can cause the bolts to loosen and ultimately cause the ball joint to detach.
    Remedy:
    Recall affected vehicles to check the torque of the bolts and if required replace the top suspension arm.
  • Announcement date:
    01/07/2010
    Recalls number:
    R/2010/042
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Rear Protection Bar May Detach
    Defect:
    It is possible that cracking can occur in the area of the welds on the mounting bracket to the tube of the rear under protection bar. This in extreme cases if not rectified could result in the detachment of the bar from the vehicle.
    Remedy:
    Recall the affected vehicles and replace the bar with a modified type.
  • Announcement date:
    01/12/2008
    Recalls number:
    R/2008/128
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Rear Axle May Become Insecure
    Defect:
    It has been identified that due to an incorrect manufacturing process the U bolts used to secure the rear axle could break resulting initially in a rattling noise emanating from the rear axle. Should this be symptom be ignored insecurity of the rear axle could result.
    Remedy:
    Recalled vehicles will have the rear axle U bolts replaced with quality assured items.
  • Announcement date:
    25/05/2007
    Recalls number:
    R/2007/035
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Fuel May Leak
    Defect:
    A crack may occur in the fuel filter water sensor which can lead to a leakage of fuel.
    Remedy:
    Recalled vehicles will have the fuel filter water sensor replaced.
  • Announcement date:
    03/12/2004
    Recalls number:
    R/2004/162
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Possibility That The Bonnet Safety Hook Is Defective
    Defect:
    The possibility exists that the bonnet safety hook (secondary locking device) is defective. With the result that should the primary lock not be fully engaged the safety hook may also fail due to lift created by the airflow and in the worst case the bonnet may open whilst the vehicle is being driven.
    Remedy:
    Likely to be affected vehicles will be recalled at which time the safety hook bracket will be checked for profile and adjusted if necessary.
  • Announcement date:
    01/07/2001
    Recalls number:
    R/2000/084
    VIN start:
    Various
    Car Build Date:
    01/01/1996 - 30/09/2000
    Concern:
    Possible Loss Of Steering Control
    Defect:
    Under severe and extreme conditions where the vehicle is used mainly off-road in a wet muddy environment it is possible that the tapered section of the ball pin on the steering 'Pitman arm' may break. This in the worst case could result in a loss of steering control.
    Remedy:
    Recall the affected vehicles and replacing the " Pitman" arm with a quality assured component.
Step 3 - Contact your nearest dealer

Enter your postcode to see your nearest franchised dealer: